Choosing the tap drill is the single biggest factor in whether a tap runs smoothly or breaks. The right size depends on what kind of tap you're using and how much thread you need.
Cut taps vs form taps
- Cut taps (hand, spiral point and spiral flute taps) cut away material to make the thread, producing chips.
- Form taps (roll form or thread forming taps) don't cut. They push the material into the shape of the thread, with no chips. Because metal is displaced upward into the thread rather than removed, a form tap needs a larger drill than a cut tap for the same thread.
Form taps work well in ductile materials like aluminum, copper and low carbon steel. They're stronger than cut taps and leave a stronger thread. They aren't suited to brittle materials such as cast iron.
What "% thread" means
Percent thread is how much of a full thread profile you actually get. A smaller drill gives more thread, but it makes tapping harder and raises the risk of breaking the tap.
The usual starting points are:
- About 75% thread for cut taps. Going much higher adds very little strength but makes the tap work much harder.
- About 65% thread for form taps.
For inch threads, with TPI = threads per inch:
- Cut tap:
% thread = (major diameter − drill) × TPI ÷ 0.01299 - Form tap:
% thread = (major diameter − drill) × TPI ÷ 0.0068
Quick chart
| Thread | Cut tap drill | Form tap drill |
|---|---|---|
| #4-40 | #43 | #38 |
| #6-32 | #36 | 1/8" |
| #8-32 | #29 | #25 |
| #10-24 | #25 | 11/64" |
| #10-32 | #21 | #16 |
| 1/4-20 | #7 | #1 |
| 1/4-28 | #3 | 15/64" |
| 5/16-18 | F | L |
| 3/8-16 | 5/16" | S |
| 3/8-24 | Q | T |
| 1/2-13 | 27/64" | 15/32" |
| M3 x 0.5 | 2.5 mm | 2.8 mm |
| M4 x 0.7 | 3.3 mm | 3.7 mm |
| M5 x 0.8 | 4.2 mm | 4.6 mm |
| M6 x 1.0 | 5.0 mm | 5.6 mm |
| M8 x 1.25 | 6.8 mm | 7.4 mm |
| M10 x 1.5 | 8.5 mm | 9.3 mm |
| M12 x 1.75 | 10.3 mm | 11.2 mm |
Tips for fewer broken taps
- Drill deep enough. Leave room below the last full thread so the tap never bottoms out on chips.
- Use a tapping fluid. Tapping generates more heat and friction than most operations; a proper tapping fluid helps a lot.
- Use less thread in tough materials. In hard or stringy materials, a slightly larger drill (less % thread) can make the difference between a tap that runs and one that breaks.
- Check the tap maker's chart for critical work. Some taps and materials have their own recommended drill sizes.
We stock taps from OSG, Balax, Brubaker, Clarkson-Osborn and more. Ask us which tap suits your material.
Questions about your application? Our technicians are happy to help. Call +1 705 728 8665 or .