Tech Tips
Practical advice from our technicians: choosing tools, tapping, coatings, and speeds & feeds.
- End Mills
Machining stainless and high-temp alloys with HTAS
Stainless steels, titanium and nickel alloys punish ordinary end mills with heat. How the Majac Mills HTAS series is built for them, with starting speeds and feeds.
- Speeds & Feeds
HEM explained: why you raise the feed on light radial cuts
High efficiency milling only works if you program enough feed. Here's how radial chip thinning works, with a quick table and a worked example.
- Speeds & Feeds
From SFM to RPM and IPM: speeds and feeds basics
The three formulas every machinist uses to turn a speeds & feeds chart into spindle speed and feed rate, with a worked example.
- Tapping
Cut tap or form tap? Tap drill sizes and % thread explained
Why a form tap needs a bigger drill than a cut tap, what "% thread" means, and a quick chart of drill sizes for common inch and metric threads.
- End Mills
Choosing the right Majac Mills series
GP, HP, UHP, HEM, HTAS or Aluminum? How to pick the Majac Mills series that fits your material, your machine and your toolpath.
- Coatings
ALL4 vs TiAlN: which end mill coating, when
The coating on an end mill matters as much as the carbide. A plain-English guide to ALL4, TiAlN, ZrN, DLC and uncoated tools, and where each one fits.