End mills rarely fail from a single cause. They fail from a combination of abrasive wear, heat and edge damage from interrupted cuts. The right coating resists the failure modes your job actually has.
TiAlN: the proven baseline
Titanium aluminum nitride has been the standard coating for steels and cast iron for years. It's proven, economical and handles heat well. It's standard on Majac Mills High Performance and Ultra High Performance tools, and available on General Purpose.
Choose TiAlN for everyday steel and cast iron work where conditions are stable.
ALL4: the broadest high-performance choice
ALL4 is a multilayer AlCrTiN coating built as a system rather than a single layer:
- A CrTiN base that bonds strongly to the carbide.
- An AlCrTiN gradient that eases the stress between layers.
- An Al/CrN nanolayer for toughness under impact.
- An AlCrTiN top layer for wear resistance at high temperature.
The result is a coating that resists several failure modes at once: abrasive wear, heat, edge chipping and interrupted cuts. It's also forgiving whether you run coolant, dry or a mix.
| Material or condition | Good choice | Why |
|---|---|---|
| Carbon and alloy steels | ALL4 | Best all-round protection against wear and heat |
| Stainless steels | ALL4 | Tough coating copes with adhesion and work hardening |
| Grey cast iron | ALL4 | AlTiN can excel in stable dry cuts; ALL4 is safer through casting skin |
| Ductile iron | ALL4 | Better edge security under higher cutting forces |
| Hardened steels | ALL4 | Broader and more forgiving than conventional coatings |
ALL4 is standard on Majac Mills HEM and HTAS tools, where heat and long engagement make the coating work hardest.
ZrN and DLC: for non-ferrous metals
- ZrN (zirconium nitride) is a low-friction coating that helps stop aluminum from welding to the cutting edge.
- DLC (diamond-like carbon) is very slick and hard. It's a good choice for abrasive non-ferrous materials such as high-silicon aluminum, and for plastics and composites.
Both are offered on the Majac Mills Aluminum series.
Uncoated (bright)
An uncoated tool has the sharpest possible edge, which suits aluminum, plastics and general work where a coating isn't needed. Majac Mills General Purpose and Aluminum tools are available uncoated.
Quick guide
| Material | Majac Mills series | Coating |
|---|---|---|
| General steel work | GP, HP, UHP | TiAlN |
| Steel, HEM toolpaths | HEM | ALL4 |
| Stainless, titanium, nickel alloys | HTAS | ALL4 |
| Aluminum, copper, brass | AL | Uncoated, ZrN or DLC |
| Plastics, graphite | GP or AL | Uncoated or DLC |
Read more in Choosing the right Majac Mills series, or ask our technicians about your application.
Questions about your application? Our technicians are happy to help. Call +1 705 728 8665 or .