Machining stainless and high-temp alloys with HTAS

Stainless steels and heat-resistant alloys like titanium, Inconel-type nickel alloys and Monel are tough on end mills. They don't conduct heat well, so heat stays at the cutting edge. Many of them also work harden: if the tool rubs instead of cutting, the surface gets harder and the next pass is even tougher.

What makes HTAS different

The Majac Mills HTAS (High Temp Alloy & Stainless) series is built for exactly this:

  • Higher-cobalt carbide grade. It's tougher and more resistant to the heat these materials generate.
  • Updated geometry and variable pitch. This reduces chatter and handles heat at the edge.
  • ALL4 coating. A multilayer coating that resists heat, wear and edge chipping. See ALL4 vs TiAlN.
  • Range. 4, 5, 6 and 7 flutes, corner radius options and longer lengths of cut, with or without chipbreakers. That's over 1,300 tools in all.

HTAS works on both conventional and HEM toolpaths, and it also performs well in general steels.

Starting speeds and feeds

From the HTAS chart, for a 1/2" tool:

MaterialSpeed (SFM)Feed per tooth at 1/2"
Stainless steels, soft300–5250.0030"
Stainless steels, hard150–4750.0020"
Monel & high nickel steel75–2500.0030"
Titanium, soft125–4750.0030"
Titanium, hard50–1950.0020"
Nickel-based high-temp alloys50–1750.0017"

Example: a 1/2" 5-flute HTAS end mill in soft stainless, at the middle of the speed range (about 412 SFM), runs at about 3,150 RPM. At a 10% radial step-over, with chip thinning applied, that's about 79 IPM.

Tips for stainless and super alloys

  • Keep the tool cutting, never rubbing. Don't let it dwell in the cut or feed too lightly. Rubbing work hardens the surface.
  • Program enough feed on light radial cuts. Thin chips mean rubbing; see HEM explained.
  • Use a rigid setup and the shortest tool that reaches. Use longer lengths of cut only when the part needs them.
  • Climb mill, and choose chipbreakers for deep side cuts so chips stay short and clear easily.
  • Start in the middle of the chart, then adjust. If the cut is stable and quiet, raise SFM and/or feed per tooth in 5–10% steps.

Browse HTAS end mills in the tool finder, or send us your part details for a recommendation.

Questions about your application? Our technicians are happy to help. Call +1 705 728 8665 or .

Looking for a reliable & stable partner?

Contact us

Sign up for our newsletter and promotions

New tools, promotions and tech tips from Majac. Unsubscribe anytime.

Call us

Are you ready to work together?

Tell us what you need and our team will get back to you within one business day.

Prefer to talk?
+1 705 728 8665

Request a quote