Aluminum (AL) end mills for aluminum & non-ferrous metals
Majac Mills Aluminum end mills are balanced pitch tools in ultra high performance carbide with polished flutes and sharp edges for clean chip flow, from roughing to finishing. Choose uncoated, ZrN to stop chips welding to the edge, or DLC for high-silicon aluminum and abrasive materials.
Best for: Aluminum and other non-ferrous metals, plastics and graphite.
Sizes available
Pick a diameter to see every Aluminum tool in that size in the tool finder, with flutes, lengths and coatings.
- 1/8"2 tools
- 3/16"28 tools
- 1/4"44 tools
- 5/16"41 tools
- 3/8"45 tools
- 1/2"47 tools
- 5/8"47 tools
- 3/4"47 tools
- 1"46 tools
Starting speeds and feeds
Surface speed (SFM) ranges and the chip load per tooth for a 1/2" diameter tool, from the Majac Mills speeds & feeds guide. Depth of cut up to 1.5× diameter for profiling and 1× diameter for full slotting. For other sizes, RPM, feed rate and chip thinning, use the speeds & feeds calculator.
| Material | SFM, Uncoated / ZrN / DLC | Chip load (in/tooth), 1/2" |
|---|---|---|
| Aluminum & Aluminum Alloys | 900–1,800 | 0.005 |
| Copper & Copper Alloys | 525–1,275 | 0.004 |
| Brass & Bronze | 375–600 | 0.004 |
| Graphite | 500–1,200 | 0.0045 |
| Plastics | 600–1,650 | 0.007 |